Here, have collected the solutions for software operation problems from Xprog-M box ECU programmer users.
1. Problem: The xprog V5.84 shows “Access violation at address 00478FC6 in module “XProgDesktop.dll”. Read of address 00000358.”
Solution: Check if the anti-virus software has been installed in the computer. If have, please close it, because the anti-virus software
will kill xprog-M driver. Then open the xprog V5.84 again. If it also doesn’t work, try to unzip xprog software again.
2. Problem: It always prompts “This program version requires to update the XPROG firmware. Do you want to update now?” when using xprog -M box.
Solution: Please check if you connect the internet, if it is, disconnect the internet. Never try to UPDATE, the hardware will be damaged if
you want to try to update it online, then you will lose its warranty.
3. Problem: My Xprog V5.84 fail to read serial eeprom, don’t give eeprom options.
Error “For information, please refer to xprog-m users manual”.
Solution: Xprog v5.84 default software CD does not have eeprom capabilities which is different from previous version V5.74/5.60/5.55 etc.
But the new v5.84 software has modified the software to enable eeprom reading.
V5.84 new software free download link:
Operating system: Windows XP/Windows 7/Windows 8
Tips for installing Xprog V5.84.
1).Disable anti-virus program when downloading software and running software.
2).Uninstall all the software and USB drivers of the old version xprog-box on your computer, then install the new XPROG5.84 software.
3).Run 5.84Regsisty program for several times when installing software
4).Run 5.84Regsisty file for 2 times before you run software every time .
4. Problem: The certificate has expired or is not validated for Xprog V6.12.
Solution: There is no need to use xprog software by internet. If you connect the internet, it will prompt you to update the software as the
picture shown above. Once you update it online, the internet may damage Xprog hardware.
To be continued…