Category Archives: Chip Tuning Tools

CAT ET

How to WinFlash Caterpillar C15 ECM with CAT ET & Flash Files

In this instruction, i will show you the guide on how to use Caterpillar ET and flash files to WinFlash for Caterpillar C15 engine ECM.   CAT WinFlash Procedures: After CAT model identification,select “Utilities” on the menu bar,and then select “WinFlash”   Now the Trainer will attempt to detect and ECM on the ATA data link. […]

Continue reading >

kess v2

Compare with KESS V2 & FGTech Galletto V54, Which one is Better for BMW M5 E60 EDC17 ?

Recently, I have been remapping a 2006 BMW M5 E60. I have heard the MPPS is not suitable for this ,so I decided to buy a better tool. Not sure if I should go for a Galletto v54 or the Kess V2. Any advice would be great, ideally I would like to get the one […]

Continue reading >

How to read, erase and program chip NEC of key Mercedes with CGDI Prog MB Benz Programmer?

  1.NEC Chip 567897041 reading and writing by CGDI MB Click on “Read /write Key”, then “NEC adapter”, then “567897041″, then “Read Key /Chip”. Read successfully, click on “Reset” until get window message “Reset operation succeed”. Back to click on “Read Key /Chip” until read success. Click on “Open /Write”. Please note: Smart key please choose […]

Continue reading >

What differences between KESS V2 V5.017 and KESS V2 V4.036 ?

1. KESS V4.036 only supports car, KESS V5.017 can support car/truck/tractor/Bike ! And V4 support cars only untill 2014, but V5 supports vehicle accroding to Engine. So V5.017 can support newer vehicle ! 2. KESS V4.036 no token limited for some car, has token limited for some other car. KESS V5.017 has no token limited […]

Continue reading >

Carprog V8.21 With All 21 Adapters user manual

Here is an user manual for Carprog V8.21 With All 21 Adapters Powering up the carprog full v8.21: CarProg can be used with external power supply (+7 – +12V stabilized), only with USB connection or with diagnostic cable ( for ex. OBDII) Standard power socket (positive in the middle) voltage in range +7…14V stabilized can be […]

Continue reading >

The different between Kess V2 V5.017 and Ktag V7.020 ECU Programmer Master

KESS V2 V5.017 and KTAG V7.020 both are universal Petrol & Diesel car/truck/tractor/motorcycle ECU Chip Tuning tools. But KESS V2 Master works better for more 12V gasoline cars, K TAG V7.020 works better for more 12V Diesel Cars and 24V trucks/tractors/motorcycles. The Vehicle Coverage for these 2 tools are different . KESS V5.017 can not […]

Continue reading >

Use KESS V2 to solve “error “

Error one: I replaced chip and reset tokens, then get connection error “External exception EEFFACE” as following picture shows. Try follow steps: Details about j-link v8 solve KESS V2 master tokens limited problem: Step 1. Buy one LPC2478 chip to replace the original one for KESS V2 master. Step 2. Prepare for a LINK J-LINK V8 […]

Continue reading >