ELM327 Plastic OBDII EOBD CANBUS Scanner V1.5 with 2102 Chip

 

Top 5 Reasons to Get Plastic USB ELM327:

1. Supports 9 protocols in all - SAE J1850 PWM, SAE J1850 VPW, ISO 9141-2 and ISO 14230-4 as well as CAN Bus ISO 15765-4.

2. Internal EEPROM can remember the last protocol.

3. Precision-moulded diagnostic connector made to fit all VW/Audi vehicles, even those with "tight" trim around diagnostic socket.

4. ELM327 with USB port, software install easily.

5. Voltage input monitors your vehicle's battery.

 

USB ELM327 Technical Specification:

ELM327 Based - Datasheet

OBDII Plug: J1962 16-Pin Male (to Car)

USB Port : (to Computer or PDA)

High quality UL certified USB Cable (equivalent to CE).

CAN (ISO 15765-4)

SAE J1850 PWM

SAE J1850 VPW

ISO 9141-2

ISO 14230-4

Automatically searches for the correct protocol or can be configured manually.

USB Port

Serial Interface uses AT commands to look like a modem.

Status LED

Length with USB Lead : 1.5 metres

 

What's New for elm327:

RS232 baud rates to 500 Kbps

Adaptive Timing automatically adjusts ST timeouts

Power up to AT MA is selectable

Source (tester) address can be changed

Can reset all PPs with a jumper

Receive addresses can be independently set

Power Control with a low power standby mode

A 4800 baud ISO option

A non-volatile memory location for storing user data

CAN extended addressing support

You can now perform ISO/KWP bus initializations without having to send a request

An SS command allows searching through the OBD protocols sequentially

A new TA command allows the Tester Address to be easily changed

Factory calibration for the voltage reading circuit can be easily restored

 

J1850: 

Complete control over in frame responses (IFRs)

Delay before protocol 2 helps with some GM/Holden vehicles

 

ISO 9141 and ISO 14230: 

The slow initiation address can now be varied

Control over key word checking

KWP protocols can now transmit 3 or 4 byte headers

 

CAN: 

New J1939 protocol

Two user-definable CAN protocols

Improved error handling and recovery

Extended addressing support

 

How To Use USB ELM327:

1. Turn the car's ignition switch ON. No need to start the engine.

2. Start the software program, click "Options", select the correct communications port.

3. Your interface now works! Make sure the software can reliably access all the control modules that it should in your car.

 

Package including:

1pc x ELM327 Interface

1pc x CD Driver

User Comment(Total 0 User Comment Num)

• No comment

Total 0 records, divided into1 pages. First Prev Next Last

Rank:
Your first & Lat Name:
Your E-mail Address:
Review detail:
Verification code: